The choice of the right cable or line for transmitting signals on your machine has essential influence on the device availability. Usually, when determining the instruments of machines and plants, a profound level of attention is directed at deciding on the best sensors.
For example, an individual determines which measuring principles are used for level measurement, which power ought to be provided to the machine and which kind of signal transmission should be used. Usually, the cables shown in the wiring schemes as simple connection lines between sensor and SPS are problematic. This poses a fascinating paradox in the automation technology ? a sensor is tested for highest demands to make sure it meets the requirements of the application form, whereas a cable is merely seen as a component which supposedly guarantees a trusted connection under all circumstances.
However, cables and connectors pose one of the most frequent resources of error. This is often where unforeseen prospect of increasing machine availability are available. During my course of research I learned that in a higher two-digit percentage of most cases, renowned cable manufacturers traced back sensor failure on machines to mechanical failure of the cable due to faulty installation, handling and especially as a result of selection of an unsuited cable for the precise application. Principally, there is no patent fix for determining which cable and which plug connector is most beneficial suitable for your application.
For instance, flexibility demands for cables used in level probes for level measurement in deep wells aren?t high, whereas the demands on tensile strength in addition to high longitudinal and transverse water tightness are. In level probes, plug connectors are barely ever applied due to the insufficient permanent leak tightness. For machine tools which are setup in factory buildings, the easiest cable materials with a simple M12 connector are employed. In Weird , however, the usage of a suitable cable that permanently withstands ambient conditions such as temperature fluctuations and that has resistance against oils and fats can significantly increase the availability of your machine.
The utilization of cable assemblies with factory pre-assembled connectors also prevents failure risk through improper on-site assembly. Therefore it is a fallacy that cables will be the same and that any given cable with the sufficient number of wires would work for an application.
In one of my previous articles, I drew up a brief overview of the most relevant criteria for choosing cables and connectors. Take your time in specifying the right cable for the application. Take into account the demands your plug connection to sensors and PLC must meet. An individually matched wiring concept offers a measurable increase of the device availability and higher safety during operation.
Should you need assistance or consulting for specifying a suitable pressure sensor and associated cable / connector, feel free to contact us.