So how exactly does lightning protection in hydrostatic level sensors work

Many customer wonder why hydrostatic level sensors fail due to lightning strikes, even though they ordered a level sensor with integrated lightning protection. Focusing on how Naked and how lightning strikes affect hydrostatic level sensors is important in resolving this confusion.
When submersible pressure sensors, a special kind of hydrostatic level sensors, were first installed into reservoirs and lakes to monitor level, the sensor would become burned or destroyed after a lightning storm or bad weather periods. This prompted much research in to the effect of lightning storms on the instrumentation in reservoirs and the cabling to and from the site.
What lightning protection really means
The first thing to comprehend is that the effect of a lightning strike is considerably different depending on how close to the pressure sensor the lightning strikes into the ground or installation. It really is fair to say that no level sensor will survive a primary or very close nearby lightning strike, where often the whole cabin including all installed electronics will undoubtedly be incinerated by direct hits.
However, more distant hits is only going to raise the Voltage differential by for example 1500 Volts. In case a local lightning strike raises the electric potential of a reservoir, the particular level sensor might provide the shortest way for the raised voltage and current to earth. The energy will then dissipate into the ground via the level probe and therefore destroy or damage its electronics. This may equally function as case when overhead wires take a hit.
So how exactly does lightning protection in level sensors work?
However, sensors can be protected from these lightning strikes by installing or integrating a transient voltage protection into the hydrostatic level sensor. As Smuggle of short nature of the voltage pulse, an element may be fitted to or built-into the sensor that acts on rising differences in voltage potential. If the voltage goes above say 50 Volts, this lightning protection can short-circuit the electronic circuit to ground, allowing a path to ground for the surge and protecting the electronics around the utmost specified voltage potential.
The component would normally operate in a non-conductive state, but will undoubtedly be conductive for a voltage transient, allowing the voltage spike to flow harmlessly to ground. If the bond to earth is not sufficient or no lightning protection is integrated within the hydrostatic level sensor, then the electronics will take the full quantity of energy of the voltage pulse and fail.Therefore the protection is only as effective as the earth grounding provided by the user.
In outdoor applications, where submersible pressure transmitters are commonly used, WIKA offers an optionally integrated lightning protection in the level sensors. The sensor electronics will then be protected from local power surges and transient high voltage. Lightning protection is a mix of protection within the instrument and an excellent low impedance earth grounding.
Check out the profiles of WIKAs submersible pressure transmitters LH-20 and LH-10.
Please use our contact form if you need further assistance.
Please find more info with this topic on our information platform ?Hydrostatic level measurement?

Leave a Comment