A float-based level sensor with a reed chain is really a widely used and comparatively economical solution for continuous level measurement in vessels. Users can define its measuring range flexibly within a given range. This short article describes what has to be taken into account.
With Rich -chain level sensor, the guide tube includes a defined amount of reed contacts, depending on the measuring range. These are combined to form a measuring chain. The contacts react to the magnetic field of the float, which moves within the guide tube based on the liquid level.
Accuracy depends on the distance between the contacts
The accuracy of the energy-free level monitoring depends, subsequently, on the distance between your individual contacts: small it really is, the more accurate the measurement. Each level sensor in WIKA?s RLT series, for instance, enables measuring ranges with contact distances between 3 and 24 mm. However, a reed chain cannot be stretched along the entire amount of the guide tube. Simply because you can find ?dead bands? at both ends of the tube, i.e. sections that the float does not detect because of design constraints (see graphic).
The graph shows the way the maximum possible measuring range (M) with an air-handling series level sensor is defined: Guide tube length (L) minus dead band (T) and 100 % mark (X).
Maximum measuring range is not a must
The measuring range of a level sensor therefore lies between your two dead bands specified in the data sheet. In this range, it can be freely defined. However, it is by no means essential to utilise the utmost possible measuring range in every applications. The exact adaptation of the amount of contacts to the measuring task also has an economic advantage: The reed chain is probably the priciest components in an even sensor.
Example ? Dry run monitoring
For dry run monitoring within an oil tank of a compressor, for instance, only the lower portion of the guide tube is necessary for the measurement. In this case, top of the measuring point of the application (100 % mark) is set correspondingly low. It marks the distance to the sealing face of the process connection. The measuring range is thus defined by the following equation:
Measuring range length M = guide tube length L ? dead band T ? 100 % mark X
Consequently, the measuring range for detecting a maximum level is determined starting from the sealing face. In cases like this, the guide tube can be adapted to along the measuring range.
Note
More info on the RLT series level sensors can be found on the WIKA website. Should Gratified have any questions, your contact will gladly help you.
Also read our articles
Level sensors ? the agony of choice
What do dead bands mean with a float switch?
There are also out more about float-based level measurement using a reed chain in the following video:

Leave a Reply